约翰迪尔 1270 E

John Deere 1270E Harvester Year: 2013 Operating hours: 24,000 Harvester head: H414 (also available with an H480 head) Crane: CH711 Machine FULLY SERVICED! Want to know more about the service work? Contact us and we’ll send you a full report, in your language, complete with photos! Cost of replacement parts: PLN 136,062 excluding VAT Scope of work completed: Engine and fluids serviced the crankcase breather filter and cleaned the radiator installed the EGR valve and resolved the cause of water accumulation in the engine oil filler neck changed the transmission oil Hydraulics and drivetrain resolved abrupt braking when releasing the accelerator pedal reconditioned the low/high range shift cylinder replaced the working hydraulic pump shaft seal reconditioned the steering cylinders repaired the driveshaft Crane and harvester head installed a new head mounting bracket and reconditioned the rotator replaced two lower and two upper delimbing knives, along with the upper knife pivot pins reconditioned the delimbing knife cylinders and replaced their pins reconditioned the outer feed roller cylinders, fitted expanding pivot pins and replaced missing feed roller studs replaced the inner feed roller cylinder seals and reconditioned the roller spacers reconditioned the right-hand outer feed roller hydraulic motor replaced the length-measuring gear and bearings and reconditioned the measuring wheel cylinder reconditioned the tilt cylinders and replaced the lift cylinder bushings serviced the crane deflection and damping sensors installed a central lubrication distribution block and adjusted the hoses at the harvester head Electrical system replaced the alternator replaced 8 work lights and installed 4 lights on the crane resolved the intermittent fuel sensor connection issue Cab reconditioned two cab stabilization cylinders replaced the control buttons on the right-hand armrest repaired the radio and door storage compartment replaced the engine hood tilt cylinder Machine condition before our service: Engine previously overhauled, with a new variable-geometry turbocharger (VTG) running smoothly, with no blow-by Hydraulics and articulation working hydraulic pump operating without issues at an 11-meter reach drive pump operating correctly, with smooth braking center articulation joint previously overhauled new main bearing and new upper and lower front pivot pins Crane crane base in like-new condition new expanding pivot pin crane leveling cylinders previously serviced expanding pivot pins fitted no play in the crane pillar suspension link and brake in like-new condition